![adjusting taylormade rocketballz driver adjusting taylormade rocketballz driver](https://pluggedingolf.com/wp-content/uploads/2014/04/RBZ-Stage-2-Driver-6.jpg)
Place the tip of the wrench into the large screw housed behind the head of the driver.
#Adjusting taylormade rocketballz driver how to#
The following steps offer a walkthrough of how to increase the default 56° lie angle of the TaylorMade M4 driver. Each movement of the sleeve alters the lie angle by 0.5° to 0.75° along with an appropriate change to the loft.
#Adjusting taylormade rocketballz driver driver#
The lie angle of the TaylorMade M4 driver can be changed by using the four-degree sleeve on the hosel of the driver and the accompanying wrench. The lie angle is the same for these drivers. The above adjustments are also applicable for the other variants of the TaylorMade M4 driver with 8.5°, 9.5° and 10.5° lofts. The table given below has the standard loft, lie angle and face angles of a TaylorMade M4 driver with 12° loft along with the eleven other settings for the same parameters. The clubface opens up when the loft is lowered and closes when the loft is raised. The lie angle and face angle change along with a change to the loft. The driver is likely to get damaged if you turn beyond this stage.
![adjusting taylormade rocketballz driver adjusting taylormade rocketballz driver](https://cdn11.bigcommerce.com/s-komfru/images/stencil/1280x1280/products/56159/244213/apipaquep__71362.1595437524.jpg)
The LOWER and HIGHER settings help to set the loft of the driver to the lowest and highest possible values. This will change the lie angle and face angle. Align the arrow marking on the clubhead with any marking apart from the STD LOFT marking present on the hosel adapter.Lift the clubhead gently from its position above the club hosel.You may have to turn the wrench a few times before the screw becomes loose. Turn the wrench anticlockwise or to the right until the screw gets loosened.Put the TaylorMade wrench into the big screw at the rear of the driver’s clubhead.The steps below will show you how to adjust the TaylorMade M4 driver using the wrench that comes with the driver. The adjustment either increases or decreases the loft from the stated value while the lie angle always increases from the standard-setting. The four-degree sleeve supports twelve sleeve movements to change the loft and lie angle by 0.5° to 0.75° as well as the face angle by 1° to 2°. The TaylorMade M4 driver can be adjusted using its adjustable hosel that features a four-degree sleeve for its adjustment. It’s possible to have twelve different options for the loft, lie angle and face angle, including the standard settings, for the same driver using its hosel. Yes, the TaylorMade M4 driver is adjustable.